2008-23 Dodge Challenger | SRT Demon Style Carbon Fiber Scooped Front Hood

Product Overview

Transform the front-end muscle aggression and powertrain thermal efficiency of your vehicle with this Demon Style Carbon Fiber Scooped Engine Hood. Specially engineered for 2008–2023 Dodge Challenger models, this functional replacement hood converts standard or Hellcat front ends into the iconic, wide-mouth SRT Demon Air-Grabber profile.

3K Twill Carbon Fiber Construction: Fabricated using real 3K 2x2 twill weave carbon fiber laminated over a high-rigidity internal skeleton frame. This dual-layer structural design drastically reduces front axle vehicle mass compared to heavy factory steel hoods while delivering exceptional rigidity against high-speed wind lifting forces.

Functional Air-Grabber Scoop & Heat Extraction: Features the signature Demon-style wide-mouth front scoop channel that forces ambient cold air into the engine bay to feed high-performance intake systems. Integrated under-hood air ducting channels and rear heat relief vents evacuate trapped engine bay heat, reducing intake temperatures and under-body air turbulence.

UV-Protected High-Gloss Clear Coat Finish: The top exterior surface is sealed beneath an automotive-grade, high-gloss UV-resistant clear coat that amplifies weave depth and guards against yellowing, water spots, and thermal fading. Molded with reinforced steel latch inserts and threaded hinge mount pads for direct bolt-on installation using original factory hardware.

Key Features

• 2008-2023 Dodge Challenger Fitment: Custom-engineered specifically for all 2008–2023 Dodge Challenger models (SXT, GT, R/T, Scat Pack, Hellcat, Demon).

• Iconic SRT Demon Air-Grabber Styling: Features the wide-mouth front air scoop for an aggressive muscle car silhouette.

• Real 3K Twill Carbon Fiber: Fabricated with authentic 3K 2x2 twill weave carbon fiber for maximum tensile strength and minimal weight.

• Functional Cold-Air Scoop & Extraction: Directs fresh ambient air into the intake bay while venting trapped engine heat to optimize thermal performance.

• Radiant High-Gloss Clear Coat: Sealed with a UV-protected gloss clear finish that guards against sun fading and weather exposure.

• Front Axle Mass Reduction: Replaces heavy OEM metal hoods to reduce front-end weight and improve overall vehicle handling balance.

• Reinforced Underside Frame Structure: Engineered with a molded inner skeleton shell for enhanced rigidity and structural stability at speed.

• 3D Precision Scanned Alignment: Scanned directly from OEM Challenger chassis coordinates to ensure tight, uniform fender and headlight margins.

• OEM Latch & Hinge Mount Provision: Built with pre-installed latch hardware pads and threaded hinge holes for direct factory-style mounting.

• Complete Replacement Panel: Ships as a full 1-piece carbon fiber engine hood assembly ready for installation setup.
  

Installation

This SRT Demon Style Carbon Fiber Hood is designed as a direct replacement for the factory engine hood on compatible 2008–2023 Dodge Challenger models.

Remove the factory hood and carefully test-fit the carbon fiber replacement before final installation. Hood alignment should be checked against the front fenders, headlights, grille area, and windshield edge before tightening the hinge hardware.

Transfer the applicable OEM hood latch striker, hinge hardware, prop rod or hood strut mounting components, and any other required factory hardware from the original hood as necessary.

Because aftermarket body panels may require minor alignment adjustments, carefully adjust the hood position and latch engagement before final tightening. Confirm that the hood opens, closes, and locks securely before driving the vehicle.

For vehicles that will be operated at high speeds or used in performance applications, aftermarket hood pins are strongly recommended as an additional safety measure.

Installation manual is not included. Professional installation is highly recommended.

Vehicle Compatibility

NOTE: Does NOT fit Shaker models — the factory Shaker hood scoop assembly requires a different hood opening and is not compatible with this hood.